TWEETER INSTALLATION

Review the Installation Precautions section of this guide before proceeding.

Flush Mounting into Removed Panels

1.Determine the tweeter mounting location, then route the wires from the crossover to the tweeter location.

2.Mark the center point of the tweeter location.

3.If using a hole saw, first drill a pilot hole, then cut out the hole using a standard 2-1/8" hole saw.

4.If not using a hole saw, use either the cardboard packaging for the tweeters or the surface mount trim

ring as a template to mark the proper size hole. Cut out the hole.

5.With the tweeter assembled, route the wires through the hole and the pressure ring and slip the pressure ring over the tweeter assembly.

6.Align the tweeter so the Viper logo faces the desired direction then push the pressure ring on to the rear of the tweeter assembly until the tweeter is snugly mounted to the panel.

7.Connect the speaker wires observing the correct polarity and re-assemble the panel.

FIGURE 2—FLUSH MOUNTING REMOVED PANELS

FLUSH MOUNT

PRESSURE

TWEETER

RING

ASSEMBLY

 

DRW-12

TWEETER WIRE

WIRING HARNESS

8

© 2002 Directed Electronics, Inc