Flush Mounting into Mounted Panels

1.Determine the tweeter mounting location, then route the wires from the crossover to the tweeter loca- tion.

2.Mark the center point of the tweeter location.

3.If using a hole saw, first drill a pilot hole, then cut out the hole using a standard 2-1/8" hole saw.

4.If not using a hole saw, use either the cardboard packaging for the tweeters or the surface mount trim ring as a template to mark the proper size hole. Cut out the hole.

5.Remove the tweeter from the flush mount housing and insert the

proper length machine bolt through the center hole of the housing and connect to the spring steel X- bracket. (See Figure 3.)

6. Connect the speaker wires observing the correct polarity.

7.Press the X-bracket portion of the assembly through the hole until its legs spring open.

8.Screw the bolt in until the tweeter housing is firmly mounted to the panel. (Make sure the arrow at the rear of the tweeter housing is pointing in the desired direction.)

9.Insert the tweeter into the housing and attach trim ring. (Refer to the trim ring information at the end of this section.)

FIGURE 3—FLUSH MOUNTING MOUNTED PANELS

FLUSH MOUNT

 

TWEETER

 

 

 

 

HEX HEAD BOLT

 

 

PANEL

 

 

X-BRACKET

 

 

 

 

 

 

 

 

 

TRIM RING

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

DRW-68

FLUSH MOUNT

 

TWEETER WIRE HOUSING

WIRING HARNESS

© 2002 Directed Electronics, Inc

9