Tweeter Surface Mounting

1.Determine the tweeter mounting location, then route the wires from the crossover to the tweeter loca- tion.

2.Place the surface mount housing against the panel and mark the two holes at the rear of the housing.

3.Drill the smaller center hole using a 1/8" drill bit. This is the mounting screw hole.

4.Drill the larger off-center hole using a 3/8" drill bit, insert a grommet and route the speaker wire from the crossover through the grommet.

5.After removing the surface mount tweeter assembly trim ring, route the tweeter wires through the larger hole in the housing and connect to the speaker wires from the crossover. (See Figure 4.)

6.Insert the excess speaker wire into the hole and position the housing so the housing will not pinch the wires after final mounting.

7.Attach the housing using the supplied screws of the correct length for a solid mount.

8.Insert the tweeter into the housing and attach the trim ring.

FIGURE 4—TWEETER SURFACE MOUNTING

10

© 2002 Directed Electronics, Inc