USER MANUAL
ENGLISH
OPERATION OF VACUUM CLEANER
BASIC OPERATION
1 2
2
4
1
1
3
1.Check that the electrical switch is switched off,
2.Then connect the suction hose (1) into the suction inlet (2) at the machine by pushing the hose forward until it is sliding in place at the inlet (to release the hose from machine just twist and pull out the hose).
3.Then connect the tubes (1) with the hose handle (2), twist the tubes in order to ensure that they are properly fitted.
4.Attach suitable nozzle (3) to the tube (1), Choose nozzle depending on what type of material that is to be
5.Connect the plug into a proper electrical outlet
6.Put the electrical switch (4) into position ”I” in order to start the motor. (GV702 has two motors/fan units and two electrical switches
Dry Operation
The use of a cloth filter bag and a dust bag will improve levels of filtration and is recommended. Always ensure that the container is emptied of any liquid before using for dry
Empty the tank when you notice that the performance is reducing or after dry
1.Switch off the machine, Release the latches (1) by pulling them outwards so that the motor top (2) is released, and remove the motor top (2).
2.Shake the filter (3) in order to remove debris. This should be done while the hose is still connected to avoid dust exiting from the open dirt container
|
|
|
|
|
|
|
| connection. After shaking the filter, wait a few moments for the dust to settle. |
|
|
| 2 |
|
|
|
| |
|
|
|
| 1 |
|
| ||
|
|
|
|
|
| Remove filter (3) from machine and empty container (4). If the filter’s | ||
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| surface appears to be heavily soiled, it is advisable to brush the filter |
|
|
|
|
|
|
|
| material clean with an ordinary soft household brush. This ensures |
|
|
|
|
|
|
|
| continued peak performance. |
|
|
|
|
|
|
|
| 3. Having emptied container (4), replace filter (3) and the motor top (2). Make |
|
|
|
|
|
|
| sure that the switch/switches is located in direction towards the suction inlet. | |
| 4 |
|
| 3 |
|
| ||
|
|
|
|
|
|
| ||
You are now ready to start again.
Wet pick up
The float valve assembly must be used at all times for wet
Always ensure that the container is emptied of any dry dust before using the machine for wet
During wet
When there is no longer liquid to be collected or the machine is full, switch off the power head, unplug the vacuum
cleaner, empty the container.
3
Emptying GV25-EU GV35-EU
1.Release the latches (1) by pulling the lower parts outwards so that the motor top (2) is released, Remove the motor top (2).
2.Disconnect the hose (3) from the inlet (4) by screwing the hose outwards.
21
4
9
