Stickers

AC1

S T E P 1 ORANGE BAG

NOTE: During assembly, it is recommended to ensure that all bolts are in place and partially threaded before completely tightening any one bolt. During assembly steps 1 thru 5, do not completely tighten any bolts until completion of Step 5.

Lay the side floor support (AC1) with the pads face down. Place the center floor support (AG1) against the side support, lining up with holes in center of the side floor support (make sure the colored stickers are side by side on AC1 & AG1). Place one flat washer (10.2x22x2) on each of two bolts (M10x70) and slide through holes, securing with one flat washers (10.2x22x2) and one nylon nut (M10) on each bolt.

Place the swing arm support (AG2) against the holes of the center floor support. Attach with two bolts (M10x70), four flat washers (10.2x22x2), and two nylon nuts (M10).

Attach the flat bracket (G10) to the inside of the swing arm support (AG2) using two bolts (M10x120), four flat washers (10.2x22x2), and two nuts (M10).

G10

AG1

AG2

11

Page 11
Image 11
Vision Fitness ST740 manual AC1, AG1 AG2