S T E P 4 GREEN BAG
Z18
Z18
AD2
AD3
AD1
C13
C13
Z19
Z19
•Both swing arm covers (C13) must be placed on the front of the main seat support with tallest sides facing rear of machine. Align bottom two holes on covers with the front two holes along bottom edge of main seat support (AC1). Attach using two bolts (M10x123), four flat washers (10.2x22x2), and two nylon nuts (M10).
•Take the swing arm without the pulleys (AD2) and align the holes at either end with the front swing arm bracket on main seat support. Slide the 105mm shaft (Z19) through holes in swing arm cover, bracket, and spacer (one 20x30x1 on each side of swing arm). Use two bolts (M10x25), two lock washers (10.2x18.4x2.5), and two flat washers (10x25x2) to secure. Repeat using the swing arm with pulleys (AD1), making sure the pulleys are down, facing the pulleys on the main seat support. Check diagram for clarification. Make sure the flats of the shafts line up with those of the mounting brackets.
•Attach foot plate (AD3) to the top of both swing arms (AD1&AD2) using one 98mm shaft (Z18), two bolts (M10x25), two flat washers (10x25x2), two lock washers (10.2x18.4x2.5), and two spacers (20x30x1) for each swing arm connection. Make sure the flats of the shafts line up with those of the mounting brackets. Tighten all hardware.
AC1
13
