Visioneer 480 manual Connect The Usb Cable And Turn On The Power

STEP 4: CONNECT THE USB CABLE AND TURN ON THE POWER 15

STEP 4: CONNECT THE USB CABLE AND TURN ON THE POWER

The Visioneer Patriot 480 scanner connects to any available USB port. Check your computer’s manual for USB port locations.

1.Remove any protective tape from the USB cable.

2.Plug the USB cable into the USB port on the scanner then into a USB port on the computer.

If the plug does not attach easily, make sure that you are plugging it in correctly. Do not force the plug into the connection.

3.Turn on the power switch, located on the back of the scanner to the left of the power port.

USB

The status light comes on and flashes indicating that the scanner is receiving power.

If you are using Windows XP or Windows Vista, and have plugged the USB cable into a USB 1.1 port, an information bubble may open explaining that “A HI-SPEED USB device is plugged into a non-HI- SPEED USB hub”. Plug the USB cable into a USB 2.0 port (if available) or just disregard the message. If you leave it plugged into the USB 1.1 port, your scanner may scan a bit slower.

Your computer then recognizes that a scanner has been plugged into the USB port and automatically loads the appropriate software to run the scanner.