• Power Saving:
The camera will automatically power off approximately 3MIN after you do not perform any operation.
7. Taking Pictures
•Taking a Picture
1.Turn on the camera.
2.The TFT panel will display 
(Snapshot Mode).
3.Point the camera at the subject; use the monitor screen to
compose the image. (If turn the Macro switch to 
, you can take picture as close as 20cm.)
6. Holding the camera still, gently press the Shutter button to take the picture.
Note: How to take a good shot? After gently pressing down shutter button, keep your hand steady for 2 seconds to get best result.
• Taking Continuous Pictures
1.Make sure the TFT Panel display 
. (Capture Function)
2.Press the Menu button and then push the joystick down to select [Burst]. Push the joystick down to select [on] and then press the OK button to confirm the setting. Push the joystick
left continuously to return to view mode and the icon 
will appear on the TFT panel. 3.Point the camera at the subject; use the monitor screen to compose the image.
4.Holding the camera still, gently press the shutter button to take the picture.
Note: Flash is deactivated at this mode. You will see the icon 
on the TFT
- 10 -
