Viewing and Downloading Your Pictures Using a PC
17
Viewing Pictures on Your Television
You can use a television to view the pictures stored in your camera. To properly display pictures on your
TV screen, your camera must be set to the correct video signal standard and must be connected to your TV.
To change the camera's video mode:
By default, the camera is set to use the NTSC video signal standard to display images on your TV. This is
the television used in the USA and Canada. If your TV uses the PAL video standard, you must reset the
camera's video mode to PAL.
You are automatically prompted to set the correct video mode the first time you use the camera. To reset
the video mode at a later time, see Setting the Video Mode on page 26.
To connect the camera to a TV:
1 Plug one end of the video cable into the TV jack located in the camera's memory compartment (behind
the rubber door.)
2 Plug the other end of the cable into the video input jack on the television.
3 Adjust the TV to use an external device as the input source.
è You will not be able to display images on the camera's LCD while your camera is connected to the TV.
To display pictures on the TV screen:
1 Turn the TV on. (Consult your TV/Monitor users guide for details.)
2 Turn the camera on. The TV will display the last picture on the memory card.
3 Press the 6 or 5 button to display the previous or next picture on the card.
To display a slide show of your pictures on the TV screen:
1 Turn the TV on.
2 Turn the camera on.
3 Press the 6 button down and hold it until the camera beeps. The TV will display a different picture
every 4 seconds.
è To reverse the order of the slide show, press the 5 button.
è To stop the slide show and resume manual control of the display, press the Select button.