DLP Projjecttor – User’s Manuall
PC Control Codes and Cable Connections
This projector provides a function to control and monitor the projector's operations by using the RS- 232C serial port.
1. Connect a
2. Launch a communication software pro- vided with PC and setup the communication condition as follows:
Baud rate | : 38400 bps |
Parity check | : none |
Stop bit | : 1 |
Flow control | : none |
Data bit | : 8 |
|
|
3. Type the command for controlling the projector and then enter the "Enter" key.
Example:
When you want to change the input to Computer 2, Type “C” “0” “6” “Enter.”
The below table shows the typical command lists for controlling the projector. Please consult your lo- cal dealer for further information of another commands.
– 97 –
