Reset and restore
There is a button in the back of the Network Camera. It is used to reset the system or restore the factory default settings. Sometimes resetting the system sets the system back to normal state. If the system problems remain after reset, restore the factory settings and install again.
Restoring the factory
defaults will erase any previous settings. Reset or restore the system after power on.
Appendix
A. Troubleshooting
Status LED
The following table lists the LED patterns in general.
Condition | LED color |
Loading system after power on | Steady green and blink red (once) |
|
|
During booting procedure | Blinking red |
|
|
Detecting and setting network | Steady green till IP address is confirmed |
|
|
After network is setup (system up) | Blinking green every other second and |
| steady red |
|
|
During the upgrade firmware process | Blink green / orange every second and fast |
| blink red |
|
|
RESET: Click on the button.
RESTORE:
1. Press on the button continuously.
2. Wait for
3. Free the button as soon as the second
- 64 -
www.vivotek.com
T: 886-2-82455282
F:
