Vivotek IP8151 manual Preset Positions

VIVOTEK

Transparent HTTP Tunnel: If you want to use your own RS-485 device, you can use UART commands to build a Transparent HTTP Tunnel� The UART commands will be sent through HTTP tunnel established between the RS-485 device and the linked camera� For detailed application notes, please refer to URL Commands on page 109 or http://www.vivotek.com/downloadfiles/faq/videoserver/UART_HTTP_Tunnel. pdf�

Preset Positions

If you select DynaDome/SmartDOME, Lilin PIH-7x00, or Pelco D protocol as the PTZ driver and click the Save button, the Preset Position button will be enabled� Click Preset Position to open the settings page� You can also select preset positions for the camera to patrol� A total of 20 preset positions can be configured.

Please follow the steps below to preset a position:

1� Adjust the shooting area to the desired position using the buttons on the right side of the window�

2� Enter a name for the preset position, which allows for up to forty characters� Click Add to enable the settings� The preset positions will be displayed under the Preset Location list on the left-hand side�

3� To add additional preset positions, please repeat steps 1~2�

4� To remove a preset position from the list, select it from the drop-down list and click Delete�

5� The preset positions will also displayed on the main page� Please refer to the illustration on the next page�

6� Click Save to enable the settings�

2

2010/12/10 17:08:56

1Functions are the same as the Control Panel on the home page

2

4

6

User's Manual - 73