Vivotek IP8352 manual Day/Night Settings

VIVOTEK

Day/Night Settings

Switch to B/W in night mode

Select this checkbox to enable the Network Camera to automatically switch to Black & White display during the night mode�

Turn on external IR illuminator in night mode

If you install external IR illuminator along with your camera with digital input signals, you can turn on the external illuminators when the camera enters the night mode�

Turn on built-in IR illuminator in night mode

Select this checkbox for the camera to turn on its IR illuminators during the night mode situations�

IR cut filter

With a removable IR-cut filter, this Network Camera can automatically remove the filter to let Infrared light pass into the sensor during low light conditions�

■ Auto mode

The Network Camera automatically removes the filter by judging the level of ambient light.

■ Day mode

In day mode, the Network Camera switches on the IR cut filter at all times to block infrared light from reaching the sensor so that the colors will not be distorted�

■ Night mode

In night mode, the Network Camera switches off the IR cut filter at all times for the sensor to accept infrared light, turn on the IR illuminators, and thus helping to improve low light sensitivity�

■ Synchronize with digital input

The Network Camera automatically removes the IR cut filter when DI triggers.

■ Schedule mode

The Network Camera switches between day mode and night mode based on a specified schedule. Enter the start and end time for day mode� Note that the time format is [hh:mm] and is expressed in 24-hour clock time� By default, the start and end time of day mode are set to 07:00 and 18:00�

Light sensor sensitivity

Select Low, Normal, or High sensitivity for the light sensor�

70 - User's Manual