REAR PANEL LAYOUT

1

2

3

4

5

6

7

8

9

1)Loudspeaker Output Jacks: This is where you can hook up an extension or external speaker cabinet(s) if desired.

Note! Hooking up a cabinet through the External jack will mute (disconnect) the internal speakers!

￿Extension: This speaker jack runs parallel with the internal speakers which are wired for 16 Ohms. The extension cabinet must be 16 Ohms.

￿External: This speaker jack will mute (disconnect) the internal speakers and you can hook up either a 16 Ohm or 8 Ohm cabinet. Be sure to set the Output Select switch accordingly.

NOTE! AC30CCH: You’ll notice the rear panel speaker jacks are labeled the same as the combos even though the head does not have internal speakers! Both jacks (External and Extension) are parallel so run cabinets as you normally would. One 16 ohm cabinet into either jack, two 16 ohm cabinets into both jacks or one 8 ohm cabinet into either jack with the impedance select switch set accordingly. See below for hook up options.

WARNING! To ensure that your system works correctly, you must observe the following points.

a)Don’t use an external speaker whose impedance is other than 8 ohms.

b)Don’t connect a speaker whose rated input capacity is less than 30 watts. The speaker may be destroyed if you ignore this caution — not recommended!

c)You must use a speaker cable to connect an external speaker. Don’t use a shielded cable like the one you use to connect a guitar to an amp.

d)You must turn off the power before connecting the cable. Connecting the cable while the power is turned on may damage your amp.

Note! It is recommended that all audio cables, with the exception of the speaker lead, used to connect to the AC30 Custom Classic are of a high quality, screened type. These should not exceed 10 metres in length. Always use a non-screened Vox approved speaker lead with the AC30 Amplifier and extension cabinets.

2)Output (O/P) Select

COMBOS

￿16 Ohm: Combos allow for the following configurations:

1)Set it to this if you use the internal speakers only.

2)Set it to this if you connect a cabinet through the External jack and the impedance is 16 ohms.

HEAD

￿16 Ohm: Head allows for the following configuration:

1)Set it to this if you use one 16 ohm cabinet. Either jack can be used.

COMBOS

￿8 Ohm: Combos allow for the following configurations:

1)Set it to this if you connect an extension cabinet through the Extension jack. You’ll be running the internal and external speakers in parallel. The impedance of the extension cabinet must be 16 Ohms.

2)Set it to this if you connect an external 8 ohm cabinet through the External jack.

HEAD

￿8 Ohm: Head allows for the following configurations:

1)Set it to this if you connect two 16 ohm cabinets.

2)Set it to this if you connect one 8 ohm cabinet.

8

Page 7 Page 9
Page 8
Image 8
Vox AC30CC2X, AC30CC1, AC30CCH owner manual Rear Panel Layout, Output O/P Select, Combos, Head
Page 7 Page 9

AC30CC2, AC30CCH, AC30CC2X, AC30CC1 specifications

The Vox AC30 series has long been a staple in the world of guitar amplifiers, renowned for its distinct sound and robust construction. The AC30CC1, AC30CC2X, AC30CCH, and AC30CC2 are four models in this celebrated line, each offering unique features and technologies that cater to various player preferences.

The Vox AC30CC1 is a single 12-inch speaker combo amplifier that boasts a vintage tone and a solid-state rectifier. This model provides two channels: Normal and Top Boost, allowing players to switch between clean and overdriven sounds seamlessly. With built-in reverb and tremolo effects, it captures the classic sounds that Vox is known for. Its lightweight design makes it easy to transport, while the iconic Vox styling remains a nod to its long-standing heritage.

The AC30CC2X features two 12-inch speakers, which enhances its overall sound projection and richness. This model also offers the dual-channel configuration, but with the addition of Celestion Alnico Blue speakers, it enhances the tonal fidelity and depth, making it ideal for more experienced players seeking a fuller sound. Like the CC1, it includes built-in reverb and tremolo, ensuring that musicians have essential effects at their fingertips.

For those who prefer a head format, the AC30CCH delivers the same legendary sound in a more versatile package. It can be connected to any speaker cabinet, allowing guitarists to customize their rig. This model is equipped with the same Normal and Top Boost channels, alongside built-in effects. Its tube-driven circuit design ensures that players enjoy the warmth and character that Vox amplifiers are famed for, while its durable construction means it is built to withstand the rigors of touring.

Lastly, the AC30CC2 is a more advanced variant that combines the features of the CC1 and CC2X in a two-channel combo amp format. It includes two Celestion speakers for fuller sound and improved low-end response. This model often becomes the go-to for those seeking the classic Vox chime combined with modern capabilities, making it a favorite among both recording artists and live performers.

Overall, each model in the Vox AC30 series offers players a unique blend of vintage charm and modern convenience, making them versatile tools that shape the sound of music across genres. With their rich tonal palette, built-in effects, and high-quality construction, the AC30 amplifiers continue to be a top choice for musicians around the world.
Top Page Image Contents