Vox E 1 owner manual Rear Panel, Midi, Output, Power Supply, Pedal

REAR PANEL

6POWER SUPPLY

6.1 ~AC9V

Connect the included AC/AC power supply here.

6.2 STANDBY Switch

This switches the unit between operating and standby conditions.

7MIDI

7.1 MIDI OUT Jack

This jack transmits MIDI data to control a connected external MIDI device.

7.2 MIDI IN Jack

This jack receives MIDI data to control ToneLab from a connected external MIDI device.

8PEDAL

8.1 VOX BUS Jack

For connecting an optional VOX Valvetronix Foot Controller pedal...a must have item, as you’ll soon discover!

NOTE: Don’t ever connect anything other than a compatable VOX foot controller to this jack!

9OUTPUT

9.1 AMP/LINE Switch

Set this switch for the device that the OUTPUT jack (or S/P DIF OUT jack) is connected to. You should set this to the “LINE” position if the output jack is con- nected to a mixer, recording device, if you are using headphones, or if ToneLab is connected to a power amp. Set this to the “AMP” position if ToneLab is con- nected to a guitar amp.

9.2 OUTPUT Jacks (L/MONO, R)

These are analogue output jacks (balanced/unbalanced TRS). Connect the L/ MONO jack if you are running in mono.

9.3 LEVEL Knob

This adjusts the level of the OUTPUT jacks and PHONE jack.

9.4 S/P DIF OUT Jack (Digital Output)

This is an optical-type digital output jack in S/P DIF format (IEC60958, EIAJ CP-1201). It digitally sends the same audio as the OUTPUT jacks at a sam- pling rate of 44.1 kHz. You can connect it to the input jack of a digital recorder or other digital audio device.

NOTE: The LEVEL knob does not control the digital output level. Refer to “Adjust- ing the digital output level,” p.50.

Introduction
Panel Tour
Setup
Program/	Manual
Creating	and Storing

11