www.vtechphones.com
40
Troubleshooting
Problem Suggestion
My cordless handset
beeps and is not
performing normally.
• Make sure the power cord is securely plugg ed into the tel ephone base. Plug the unit into a
different working electrical ou tlet not controlled by a wall switch.
• Move the cordless ha ndset closer to the telephone base. It may be o ut of range.
• Reset the telepho ne base by unplugging the uni t’s electrical power. Wait for 15 seconds an d
plug it back in again. Allow up to one minute for the cordless handset and the telephone base
to synchronize.
• Other el ectronic produc ts can cause interference to your cordl ess telephone. Try installing
your telephone as far away from these electronic devices as possible: wireless routers, radios,
radio towers, pager towers, cellular telephones, intercoms, room monitors, televisions, personal
computers, kitchen appliances an d other cordless telephones.
Common cure for
electronic equipment
• If the unit is not responding normall y, try putting the cord less handset in the tele phone base
or the charger. If it does not seem to respond, try t he following (in the order listed):
• Disconnect th e power to the telephone base.
• Disconnect th e battery on the cordless hand set.
• Wait a few minutes before conne cting power to the telephone base.
• Re-install the b attery and place the cordles s handset into the telephone base or ch arger.
• Wait for the cordless handset to synchronize its connect ion with the telephone base. Allow up
to one minute for this to take place.