VTech DS6121-2, DS6121-3, DS6121-5, DS6122-5 Set telephone base ringer, Set remote access code

Answering system

Set telephone base ringer

This feature allows you to select the telephone base ringer volume level. You can choose from HI (high), OF (off) or LO (low).

1.Press SETUP when the telephone is not in use until the system announces the telephone base ringer setting.

2.Press /SKIP or /REPEAT until the system announces the desired telephone base ringer volume level, then press SETUP to save the setting and go to the next setting, or press /PLAY/STOP to save and exit setup mode.

Set remote access code

A two-digit security code is required to access the answering system remotely from any touch tone telephone. The preset code is 19. You can set the code from 10 to 99.

To set the remote access code:

1.Press SETUP when the telephone is not in use until the system announces the remote access code setting.

2.Press /SKIP or /REPEAT to change the remote access code by one, or press and hold /SKIP or /REPEAT to change it by increments of ten. Press SETUP to save the setting and go to the next setting, or press /PLAY/STOP to save and exit setup mode.

•The handset ringer volume is set separately. See page 8 for details.

Basic operationAnswering system

www.vtechphones.com 37