Wall Mounting | VTech VT 9152 specification

WALL MOUNTING

1.Choose a spot near an electrical outlet and a telephone jack.Your phone requires a modular telephone jack and a standard electrical outlet (120V AC). The power cord is six feet long; make sure there is an electrical outlet within reach of the base. The outlet should not be controlled by a wall switch. If the switch is ever turned off, the phone will not operate.

2.Attach the wall mount bracket to the slots located on the underside of the Base Unit.

3.Mount the Base on the wall. Position the wall mount bracket so that the 2 holes in the bracket are aligned with the wall studs. Position the power and telephone line cords to extend down the wall to which the phone is to be mounted.

4.Connect the power cord. Plug the DC connector into the DC jack on the bottom of the Base Unit. Plug the AC power adapter into an electrical outlet.

5.Connect the telephone line cord. The telephone line cord has a snap-in plug at each end. Insert one of the plugs into the jack on the bottom of the base. Insert the other end of the plug into the wall jack.

wooden stud

wallboard

GETTING STARTED

7

Image 7

VTech VT 9152 important safety instructions Wall Mounting

Contents

Table of Contents Additional Information Important Safety Instructions Parts Check List Introduction Replacing the Handset Batteries Recharging the Battery PackGetting Started Getting Started Setting UP Your VT Wall Mounting Handset Features and Keys Getting Started Base Unit Features and Keys Getting Started Basic Operation Using Your VT 9152 Cordless Telephone Basic Operation Call Screening from Base Unit Basic Operation Answering System OperationIntroduction USE the VT 9152 Handset to Program Your Answering System KEY Function Handset Layout for Answering System Operation Answering System Setup Recording a Memo SET Base RingerSET Number of Rings Checking DAY and Time To Hear Your Outgoing Greeting Playback of GREETINGS, Messages and Memos Remote Operation of Your VT 9152 Answering System Remote Commands Belt Clip Headset OperationOperation No Dial Tone Handset does not Ring When YOU Receive a CallCase of Difficulty Phone DOESN’T Work AT ALL Answer ON/OFF Light on the Base Unit is Blinking YOU Hear Other Calls While Using Your PhoneYour Caller Fades in and OUT Your Answering System is not Recording Messages What is not covered by this limited warranty? Limited Warranty StatementWhat does this limited warranty cover? How long is the limited warranty period? Other limitations How do you get warranty service? FCC Part FCC and IC RegulationsIC Industry Canada Rbrc R Seal Taking Care Ofyourtelephone Maintenance Technical Specifications Page Issued