Vulcan-Hart GPC12S, ML-126881, ML-126883 manual Casters

Casters

1.Position the pasta cooker in an open space near the final installation area.

2.Tilt pasta cooker on its side. Be careful not to scratch the finish.

3.Thread casters into mounting holes provided on the bottom of the pasta cooker by screwing in a clockwise rotation until tightened.

4.Carefully raise pasta cooker to its normal position and place it in the installing location.

NOTICE: When the pasta cooker is mounted on casters, it must be installed with the casters supplied, a connector (not supplied by Vulcan-Hart) complying with either ANSI Z21.69 (latest edition) or CAN/ CGA-6.16 (latest edition), and a quick disconnect device complying with either ANSI Z21.41 (latest edition) or CAN1-6.9 (latest edition). It must also be installed with restraining means to guard against transmission of strain to the connector, as specified in the appliance manufacturer's instructions. Attach the restraining device at the rear of the oven. (Fig. 1).

Provide a gas line strain relief to limit movement of the pasta cooker without depending on the connector and any quick-disconnect device or its associated piping to limit the pasta cooker's movement. Attach the strain relief to the rear of the pasta cooker (Fig. 1).

Should it be necessary to disconnect the gas line strain relief, turn off the gas supply before disconnection. Reconnect this restraint before turning the gas supply on and returning the pasta cooker to its installation position.

STRAIN RELIEF FITTING FOR GAS LINE THIS SIDE ONLY . (Strain relief fitting supplied by Vulcan - Hart . Chain to be supplied by others . )

PL-51493

Fig. 1

Instructions for installing casters to the pasta cooker are included with the casters. Pasta cooker/chill tank combination units are shipped with legs or casters already assembled.

– 7 –