Vulcan-Hart VCD44 ML-138069 Access Panel Positioning, Legs Installation, Cleaning, Location

VCD SERIES CHIP WARMER F-38053 (09-10)

ACCESS PANEL POSITIONING:

1.Ensure that top Baffle notches are over carriage bolts.

2.Insert Access Panel onto the back of the Chip Warmer. (Fig. 1)

(Fig. 1)

3.On both sides of Access Panel, place clips into slots, then lock. (Fig. 3)

(Fig. 2)

LEGS INSTALLATION:

1.To install legs, carefully tip Chip Warmer onto its side. Screw legs into pre-drilled holes. Return warmer to the upright position.

4

SCOOP HOLDER INSTALLATION:

The Chip Scoop Holder will secure up to a 6“ wide scoop.

1.On either the left or right side of the Chip Warmer, loosen four side screws one revolution.

2.Position the Chip Scoop Holder. (Fig. 3)

(Fig. 3)

3.Tighten four side screws.

CLEANING:

The warmer should be thoroughly cleaned prior to putting into service. Please refer to cleaning instructions on page 6.

LOCATION:

For efficient warmer operation, choose a location that will provide easy loading and unloading without interfering with the final assembly of food orders.

The installation location must allow adequate clearances for servicing and proper operation.