VCD SERIES CHIP WARMER |
OPERATION
BEFORE FIRST USE |
| TESTING THE CHIP WARMER |
The Chip Warmer should be thoroughly cleaned before initial use.
Always disconnect electrical power to the Chip Warmer before cleaning or servicing.
1.Remove Access Panel by unlocking clips.
2.Place Access Panel away from Chip Warmer.
3.Remove Top Door.
4.Remove all internal Baffles through back opening.
5.Using a soft, clean cloth, clean Top Door and Baffles with a solution of mild detergent and warm water. Rinse with a soft cloth and warm water. Wipe dry with a soft dry cloth.
Never spray the unit with a hose.
6.Using a soft, clean cloth, clean the inside of the unit with a solution of mild detergent and warm water. Rinse with a soft cloth and warm water. Wipe dry with a soft dry cloth.
7.Replace Top Door and all internal Baffles.
8.Reattach Access Panel.
The Warmer and its parts are hot. Be very careful when operating, cleaning, or servicing the warmer.
Before using the Chip Warmer for the first time, verify that it operates properly.
1.Verify that the Chip Warmer is connected to the correct power source.
2.The Lighted Power Switch is located on the top rear of the Chip Warmer. Switch power switch to ON position. Verify that the switch illuminates. (Fig. 5)
(Fig.5)
3.Check the interior rear of warmer to ensure that it is heating. The internal thermostat is factory preset to 180⁰ F. The blower fan circulates heated air through the perforated removable chip tray located at the bottom of the interior of the cabinet (under the chips.)
6
