VCD SERIES CHIP WARMER |
ELECTRICAL REQUIREMENTS
ELECTRICAL CODES & STANDARDS:
The warmer must be installed in accordance with:
In the United States of America:
1.State and Local Codes.
2.National Electrical Code, ANSI/
National Fire Protection Association, Batterymarch Park, Quincy, MA 02269.
In Canada:
1.Local Codes.
2.Canadian Electrical Code, CSA C22.1 (latest edition.) Copies may be obtained from: The Canadian Standard Association, 178 Rexcale Blvd., Etobicoke, Ontario, Canada M9W 1R3.
ELECTRICAL CONNECTIONS:
The warmer is factory wired for 110/120 volt single phase operation. All 110/120 volt warmers are equipped with a 8 foot cord and NEMA
The cord and plug supplied is a suitable durable cord with a molded
5
All warmers are equipped with a
Verify that the power source matches the Serial Data Plate located on the lower back corner of the warmer and the plug configuration before the connection is made. (Fig. 4)
SERIAL DATA PLATE
(Fig. 4.)
A separate disconnect switch or circuit breaker is recommended to be placed at a convenient location between the Chip Warmer and the electric power source.
To avoid damage to the power supply cord, cord retainer bushing, or electrical outlets, always check to be certain that the power cord is unplugged from the power source before moving the unit.