Vulcan-Hart VW3D ML-126512, VW2SB ML-126503, VW1S ML-126500 General, Installation, Unpacking

Installation, Operation and Care of

MODEL VW SERIES DRAWER WARMERS

PLEASE KEEP THIS MANUAL FOR FUTURE USE

GENERAL

Vulcan-Hart Drawer Warmers are produced with quality workmanship and material. Proper installation, usage, and maintenance of your drawer warmer will result in many years of satisfactory performance.

It is suggested that you thoroughly read this entire manual and carefully follow all of the instructions provided.

The VW Series Drawer Warmers provide an efficient means of holding a variety of prepared hot food products at proper temperatures until serving.

•VW-S and VW-SB series have a large 15x20" (38x51cm) over-sized drawer insert.

•VW-D, VW-C, VW-CB, and VW-DB series have a standard 12x20x4" (30x51x10 cm) steam table pan insert.

INSTALLATION

Before installing, verify that the electrical service agrees with the specifications on the rating plate located on the lower rear corner of the drawer warmer. If the supply and equipment requirements do not agree, do not proceed with the installation. Contact your Vulcan-Hart office immediately.

UNPACKING

This drawer warmer was inspected before leaving the factory. The transportation company assumes full responsibility for safe delivery upon acceptance of the shipment. Immediately after unpacking, check for possible shipping damage to the drawer warmer. If the drawer warmer is found to be damaged, save the packaging material and contact the carrier within 15 days of delivery.

Carefully unpack drawer warmer and place in a work-accessible area.

1.Remove banding material holding the carton to the pallet.

2.Remove cardboard carton and plastic bag covering drawer warmer.

3.Carefully lift drawer warmer off carton bottom and place it on the floor or table.

4.Remove legs from the drawer of the drawer warmer.

5.Secure legs to the bottom of the drawer warmer by screwing legs into the holes provided.

6.Remove any and all packaging materials in drawers.

– 3 –