OPERATION
During the first few minutes of initial use, you may notice a slight odor; this is normal and will quickly disappear.
Overheat Indicator Power Indicator
Power | Thermostat |
Switch | Dial |
TO OPERATE
1.Place the product on a flat, steady, stable,
2.Plug the Power Cord into a standard 120V AC electrical outlet.
3.To turn on the heater, rotate the Power Switch to the desired setting: FAN (no heat), LOW (500 watts), MED (1000 watts), or HIGH (1500 watts).
4.Set the Thermostat Knob to the desired level.
5.To turn off the heater: rotate the Power Switch to the “OFF” position.
6.Unplug the product from the electrical outlet if leaving it unattended or while it is not in use.
TO SET THE THERMOSTAT
1.Turn the Thermostat Knob clockwise all the way to the end of its range.
2.Allow the heater to warm up until the ambient room temperature reaches your desired comfort level.
3.Slowly turn the Thermostat Knob counterclockwise until the heater turns off. Turn knob slightly clockwise until heater turns on again.
4.The heater will start up again and turn off to maintain the current room temperature at that thermostat setting.
NOTE: The lower the thermostat setting, the lower the room temperature. The higher the thermostat setting, the higher the room temperature.
6
