TROUBLE SHOOTING
Trouble | Possible Cause | Solution |
Pressure drops or | - Lack of water | - Open the water tap |
oscillations | - Nozzle is dirty | - Clean the nozzle of possible debris with tip |
|
| cleaner. |
The motor hums when | - Main voltage too low | - Check the electrical connection |
switched on and fails to | - Gun not activated | - Switch machine ON and operate the gun |
start | - Extension cord too | - Use an extension cord of sufficient size |
| small | - Check the electrical requirements in safety |
|
| instructions (page 4) |
The motor stops | - Overload | - Check to see if power voltage is correct. |
| disconnected due to | Rest over load switch, wait 3 minutes and then |
| motor overheating | switch the appliance on again. |
The detergent fails to | - Clogged injector | - Clean the soap injector by using the tip |
come out soap spray |
| cleaner |
bottle |
|
|
Generates an irregular | - Dirty high pressure | - Clean the high pressure nozzle with the tip |
and | nozzle in the spray | cleaner |
| gun |
|
|
|
|
SERVICE CENTER
If you have any question in regards to the operation of this power tool or are in need of a spare part please contact our service center at:
Wachsmuth & Krogmann, Inc. Tel:
(Business hours
ENVIRONMENTAL PROTECTION
If the tool should no longer work at all, please make sure that it is disposed in an environmentally friendly way, by handing it into a public collection point. Please do not put it with your household waste.
21