Wacom DTF-720 manual Adjusting the Stand, Installing PL-720 on a Mount Arm

Adjusting the Stand
1Pull up on the stand adjustment lever.	1

Caution	2
Please hold the stand carefully as

you adjust it to prevent injury or damage to the product.

2Lower the stand carefully.

Installing PL-720 on a Mount Arm

This product conforms to the Video Electronics Standard Association’s (VESA) Flat Panel Monitor Physical Mounting Interface Standard (FPMPMI).

This product can be removed from the stand and mounted on such apparatuses as a VESA-standard mount arm. In order to do this, M4/0.7 mm screws, which are not included with the product, are needed. Use screws that will, at the time of installation, penetrate the surface of the product by no more than 15 mm. Use of longer screws may result in damage to internal parts of the

product.

1Make sure that both your computer and the product are turned off and that all cables are disconnected.

2Place the display unit face down on a flat surface. To prevent harm to the front of the unit, fi rst spread a cloth or similar material on the fl at surface as a cushion.

3Remove the four screws that hold the stand to the unit.

4Using four M4/0.7mm screws, securely mount the arm or similar apparatus to the back of the unit.

5Connect the cables and save the screws that you removed in step 3.

Caution

When installing the unit on a mount arm or other stand, always follow the directions in the instruction booklet for the mount arm or stand, as well as the instructions contained in this document. Incorrect installation may result in the product coming loose and falling, possibly causing product failure.

6

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿ ￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿