BEFORE YOU BEGIN | THIS PAGE CONTAINS INFORMATION THAT WILL BE |
REPEATED THROUGHOUT THE MANUAL. |
LOCKING AND UNLOCKING THE GUN
WARNING
Always lock the trigger off when attaching the spray tip or when the spray gun is not in use.
LOCKING THE GUN
The gun is secured when the trigger lock is at a 90° angle (perpendicular) to the trigger in either direction.
UNLOCKING THE GUN
To unlock the gun, turn the trigger lock to be in line with the trigger.
The spray tip SHOULD NOT be attached until after the sprayer and spray hose has been purged and primed.
PLUGGING IN THE SPRAYER
1.Check that the ON/OFF switch is in the OFF postion.
2. Plug the sprayer into a | O |
| |
heavy duty grounded |
|
extension cord (refer to |
|
Important Electrical |
|
Information, page 3). |
|
PRESSURE RELIEF PROCEDURE
WARNING
Be sure to follow the pressure relief procedure when shutting the unit off FOR ANY PURPOSE. This procedure is used to relieve pressure from the spray hose.
1. Lock the spray gun off and flip the ON/OFF switch to the OFF position.
|
| O | PRIME | SPRAY |
2. | Turn the PRIME/SPRAY |
| ||
|
|
| ||
| knob to PRIME. |
|
|
|
3. | Unlock the spray gun and |
|
|
|
| then trigger it onto a scrap |
|
|
|
| piece of wood or cardboard. |
|
|
|
4. | Lock the spray gun. |
|
|
|
EMPTYING THE HOPPER
Follow these instructions if the hopper is filled with material and 1) your sprayer malfunctions or 2) you finish your spraying project without using all the material in the hopper.
1. Perform all the steps of the Pressure Relief Procedure (page 5).
O
2.Remove the lid from the hopper.
3.Grab top handle of the sprayer with one hand, grab rear handle with the other.
4.Lift and tilt the sprayer so that material will pour from one of the front corners of the hopper and into its original container.
Top
handle
Rear 
handle
Front corners
| WARNING |
|
| CAUTION |
| |
The unit, when filled with | Make sure your floors and | |||||
spraying material, can be | furnishings are protected | |||||
heavy. Make sure to lift | with drop cloths to avoid | |||||
with your legs and not your | ||||||
| property damage. | |||||
back in order to reduce the |
| |||||
|
|
| ||||
| risk of injury. |
|
|
| ||
PAINT STRAINING
It is recommended that in order to avoid premature tip and filter clogging you should strain your paint before spraying. Follow manufacturer’s recommendations.
CHOOSING THE CORRECT SPRAY GUN FILTER
Use the proper gun filter based on the tip size being used.
Part No. | Tip Size | Filter | Mesh | Color of | Qty. |
|
| Type | Number | Filter |
|
|
|
|
| Body |
|
0154918 | .011 | Extrafine | 180 mesh | red | 2 pack |
|
|
| 0.084 mm |
|
|
|
|
|
|
|
|
0154675 | .013 | Fine | 100 mesh | yellow | 2 pack |
|
|
| 0.140 mm |
|
|
|
|
|
|
|
|
© 2003 Wagner Spray Tech - All rights reserved. | 5 | Customer Service: | English |
|
|
|
|
