STORAGE
SHORT-TERM STORAGE (UP TO 16 HOURS)
Follow these steps when using LATEX PAINTS ONLY. If using materials that are
SHUTDOWN
1.Perform all the steps of the PRESSURE RELIEF PROCEDURE (page 5).
PRIME | SPRAY | O |
|
|
2.Pour 1/2 cup water slowly on top of the paint to prevent it from drying. Replace the hopper lid.
3.Wrap the spray gun assembly in a damp cloth and place it in a plastic bag. Seal the bag shut.
4.Unplug the sprayer.
5.Place the sprayer in a safe place out of the sun for short- term storage.
STARTUP
1.Remove the gun from the plastic bag and stir the water into the paint.
PREPARING THE SPRAYER FOR LONG- TERM STORAGE
1.Make sure you have already completed the Cleanup steps on pages
2.Remove the inlet filter. You may need to use a screwdriver to pry it loose.
Inlet filter
3.Pour approximately two ounces of light household oil into the inlet valve.
Inlet valve
4.Remove hose from outlet valve, place a rag over the outlet valve, and turn the switch ON. Let the unit run for five seconds.
5.Switch the pump OFF.
O
2.Check to be sure the PRIME/SPRAY knob is set to PRIME.
3.Plug sprayer in and turn the switch to ON.
4.Turn the PRIME/SPRAY knob to SPRAY.
5.Test the sprayer on a practice piece and begin spraying.
PRIME | SPRAY |
SPRAY
PRIME
6.Replace the inlet filter and push the tab on the filter.
Tab
7.Wipe the entire unit, hose and gun with a damp cloth to remove accumulated paint.
8.Replace the high pressure hose to the outlet valve and replace the hopper lid.
© 2003 Wagner Spray Tech - All rights reserved. | 11 Customer Service: | English |
|
|
|
