Step 6: Mounting Door Bracket
WARNING: Fiberglass, aluminum and steel doors must be reinforced to prevent damage to the door. Check with your ga- rage door manufacturer for their recom- mendations.
Reinforce light weight doors, as illustrated.
For wood doors, mount door bracket, using two
For metal doors, mount door bracket, using two
Step 7: Installing Light
Remove diffuser cover by pressing on both sides of the bottom of the lighting cover at the junction of the housing, releasing the locking tabs, and pulling forward. Screw a 60 Watt bulb (60 Watt Maximum) into socket. For maximum bulb life, “rough service” bulbs are recom- mended. Align top and bottom tabs on cover to Motor Power Head Unit and push straight on until cover locks into place.
Note: light turns on automatically when door is activated and a 4 minute time delay circuit automatically turns light off, allowing am- ple time to enter the house. A fully open door with light blinking indicates an obstruction or problems with external safety sensors during close travel. See trouble shooting section for further details.
Step 8: Installing Wired Wall Station (if included)
WARNING: Install all wall controls out of the reach of children and in a location where the door can be seen before activating. Do not mount wall controls near or next to garage door.
Wired Wall Station: Wire the garage door opener wall station using bell wire (low voltage electrical wire) connected to COM and P.B. on vertical screw terminal strips, as illustrated.
Locate push button adjacent to service entrance door at a minimum height of 5 ft., and at least 5 ft. away from garage door (see illustration in Step 10). Fasten the wall station in a safe location with the (2) Phillips head screws, making sure not to over tighten. Pilot drill mounting holes
using a 3/32" bit. Additional wired wall stations may also be installed in accordance with these instructions.
CAUTION: Over tightening the screws could deform plastic.
13
