Wayne 3514, 3014, 3018DLX user manual Step One Rail Assembly, Step Two: Trolley Alignment

Rail Assembly

WARNING: DO NOT RUN OPENER UNTIL INSTRUCTED TO DO SO!

Step One: Rail Assembly

Pre-position parts for assembly. Bolt a splice bracket to the motor head assembly and bolt the intermediate rails to the same splice bracket, using 5/16” x 1/2” carriage bolts and 5/16” lock washer nuts. The rounded head must be on the inside of the rails and the nuts outside. Bolt the other splice bracket to the intermediate rails, leaving the four holes on the splice bracket open for the front rail assembly.

NOTE: Keep in mind that the rails will have to be adjusted later, so only finger tighten the bolts first. The bolts will have to be tightened after the rail alignment is achieved.

Step Two: Trolley Alignment

Ensure the rails fit between the upper and lower trolley guides and the chain guard and pin are oriented as shown in the illustration.

Step Three: Mounting Front Rail Assembly

Fasten the front rail assembly to the intermediate rails using the splice bracket and four 5/16” x 1/2” carriage bolts and 5/16” lock washer nuts.

9