Return to Section
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master
Return to Master TOC
Return to Master TOC
Return to Master TOC
REASSEMBLY OF LIFT BAIL
1.Place the lift bail onto the IDE- ALARC
2.Using a 9/16” socket wrench, attach the four bolts and associated wash- ers mounting the lift bail to the base assembly.
3.Using a 9/16” socket wrench, attach the four bolts mounting the lift bail to the main transformer assembly.
4.Using a 3/8” socket wrench, attach the two screws holding the input contactor bracket to the lift bail.
5.Reattach leads #217 and #222 to resistor R2.
6.Reattach or reconnect any cables or wire ties previously removed.
7.Using a 5/16 (8mm) nut driver or flat head screw driver, attach 20 screws (ten per side) to secure case sides, and 2 screws to secure top.
