TOC

TOC

A-9

INSTALLATION

A-9

 

 

CONNECTION FOR AIR/CARBON ARC

3. If necessary, disconnect all wire feeder control

CUTTING OPERATION

 

cable connections from the DC-1000 terminal

 

 

strip.

 

Return to Section

Return to Master

WARNING

THE OUTPUT TERMINALS ARE ENERGIZED AT ALL TIMES WHEN THE IDEALARC DC-1000 IS CONNECTED FOR AIR/CARBON ARC CUTTING.

____________________________________________________

4.Remove the leads from the unit by pulling them through and out of the strain relief box connector

(s).

5.Connect a jumper wire from terminal #2 to termi- nal #4 on the terminal strip.

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

1. Set ON/OFF PUSH BUTTON to OFF.

6. Set the Welding Mode Switch to the CV(I) position

for air/carbon arc cutting.

 

2.Locate and open the access door on the Front Case Assembly.

IDEALARC DC-1000

Page 15
Image 15
Lincoln Electric SVM123-A service manual Connection for AIR/CARBON ARC, Cutting Operation