Wayne-Dalton 347610 Label Placement, Ceiling member, 16-18 x 1-1/4 Parallel to door

	Horizontal tracks
	Vice clamp
Vice clamp	2nd Track roller

3/4” To 7/8”	3/4” To 7/8”
	Door edges
	Horizontal tracks

Rear center

Horizontal

back hang

Sound framing

members

track(1) 3/8” Truss head bolt (may not be supplied)

(1) 3/8” Nut

(may not be supplied)

Horizontal

track

Drill 3/8”

diameter hole

Center of the horizontal track

25	Label Placement
	Tools: Step Ladder

IMPORTANT: Using the illustration, attach the appropriate labels to the ap- propriate location on the section, as shown.

Perforated angle bolted using (2) 5/16” x 1-5/8” hex head lag screws to ceiling member and parallel to door

NOTE: The Spring Warning tag(s) are factory attached (one per spring).

NOTE: Because of different configurations, some labels may require minor relocations.

Torsion spring tag(s) (one per spring)

Horizontal track

(3) 5/16” Bolts and nuts

Perforated angle

WARNING

Residential Dust label

(For California Residents Only)

HIGH SPRING TENSION CAN CAUSE SERIOUS INJURY OR DEATH.

DO NOT adjust, repair or remove springs or parts to which springs are connected, such as steel brackets, cables, wood blocks, fasteners or other parts of the counterbalance system.

Adjustments or repairs must ONLY be made by a trained door systems technician using proper tools and instructions.

DO NOT remove, cover or paint over this tag. Product user should inspect this tag periodically for legibility and should order a replacement tag from the door manufacturer, as needed.

5/16”-18 x 1-1/4” Hex bolts must extend into the track to serve as a roller stop

Residential

warning label

WARNING

WARNING

Sound framing members

(3) 5/16”
Bolts and nuts
Horizontal	Perforated angle bolted
track	using (2) 5/16” x 1-5/8”
	hex head lag screws to
Perforated angle	ceiling member and
5/16”-18 x 1-1/4”	parallel to door
Hex bolts must extend into the
track to serve as a roller stop

Lift handles/gripping points are required			Lift handles/gripping points are required
on this door, located as spelled out in the			on this door, located as spelled out in the
installation instructions, even if the door			installation instructions, even if the door
is motor operated.			is motor operated.
Failure to install and use these lift handles/			Failure to install and use these lift handles/
gripping points on this door can result in			gripping points on this door can result in
serious injury to fingers and/or hands, if			serious injury to fingers and/or hands, if
placed in the opening between sections,		IMPORTANT	placed in the opening between sections,
when the door is operated manually.			when the door is operated manually.
WARNING		THIS WOOD PRODUCT REQUIRES PROPER	WARNING
		ACC0RDANCE TO THE DIRECTIONS GIVEN IN THE
		FINISHING PRIOR TO ANY DOOR HARDWARE BEING
		APPLIED. BOTH INNER AND OUTER FACES OF THE
		SECTION(S), AS WELL AS ALL EDGE SURFACES
	important notice	MUST BE PREPARED AND FINISHED IN STRICT
The adjacent bottom corner bracket and		AND/OR DELAY IN FINISHING, THAT ALLOWS FOR	The adjacent bottom corner bracket and
	Wood label	MANUAL UNDER “MAINTENANCE AND PAINTING
		INSTALLATION INSTRUCTIONS AND OWNER’S
all cable retention features including		INSTRUCTIONS FOR ALL WOOD DOORS”.	all cable retention features including
milford pins, cotter pins, & clevis pins are		IMPROPER STORAGE, IMPROPER TRANSPORTATION	milford pins, cotter pins, & clevis pins are
under HIGH SPRING TENSION.		THE EXPOSURE OF THIS WOOD PRODUCT TO	under HIGH SPRING TENSION.
Adjustments and repairs must only be		THE LIMITED WARRANTY.	Adjustments and repairs must only be
		MOISTURE AND/OR OTHER CONTAMINANTS, VOIDS
made by a trained door systems			made by a trained door systems
technician, using proper tools and			technician, using proper tools and
instructions.			instructions.
DO NOT REMOVE, COVER OR PAINT OVER			DO NOT REMOVE, COVER OR PAINT OVER
THIS LABEL. PRODUCT USER SHOULD			THIS LABEL. PRODUCT USER SHOULD
INSPECT THIS LABEL PERIODICALLY FOR			INSPECT THIS LABEL PERIODICALLY FOR
LEGIBILITY AND SHOULD ORDER A			LEGIBILITY AND SHOULD ORDER A
REPLACEMENT FROM THE DOOR	Bottom section warning labels		REPLACEMENT FROM THE DOOR
MANUFACTURER AS NEEDED.			MANUFACTURER AS NEEDED.

16

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer,

refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com