![](/images/new-backgrounds/1058660/5866043x1.webp)
23 | Rear Support |
|
|
| |
Tools Needed: | WARNING | DOOR IN THE |
UP POSITION | ||
|
| |
Ratchet Wrench | Keep horizontal track |
|
|
| |
1/2” Socket | parallel and within 3/4” |
|
maximum of door edge, |
| |
|
| |
1/2” Wrench | otherwise door could fall, |
|
| resulting in severe injury or |
|
(2) Vice Clamps | death. |
|
Step Ladder | Raise the door until the top section and half |
|
| of the next section are in a horizontal position. |
|
| Do not raise door any further since rear of |
|
| horizontal track is not yet supported. | vice |
| WARNING | |
| clamps | |
| Raising door further can |
|
| result in door falling and |
|
| cause severe injury or death. |
|
| Clamp a pair of vice clamps on the vertical |
|
| tracks just above the second roller on one |
|
| side, just below the second roller on the other |
|
| side. This will prevent the door from raising or |
|
| lowering while installing the rear support. | vertical |
|
| |
| Using perforated angle, 5/16” x | TRACK |
|
| |
| head lag screws and 5/16” bolts with nuts |
|
| (may not be supplied), fabricate rear support |
|
| for horizontal tracks. Attach horizontal tracks to |
|
| the rear supports with 5/16”- 18 x |
|
| bolts and nuts (may not be supplied). Horizontal |
|
| tracks must be level and parallel with door. |
|
| NOTE: If rear supports are to be installed over |
|
| drywall, use 5/16” x 2” hex head lag screws |
|
| and make sure lag screws engaged solid |
|
| structural lumber. |
|
| NOTE: If an idrive® opener will be installed, |
|
| position horizontal tracks one hole above level |
|
| when securing it to rear supports. |
|
| Adjust weather seal (if necessary). Now |
|
| permanently attach the weather seal to both |
|
| door jambs and header. (Temporarily attached in |
|
| PREPARING THE OPENING on page |
|
| pushing weather seal too tightly against face |
|
| of door. | Edge |
| WARNING | |
|
| Door |
| Prior to winding or making adjustments | 1/2”- 5/8” |
| to the springs, ensure you’re winding in | |
|
| |
| the proper direction as stated in the |
|
| Installation Instructions. Otherwise, |
|
| the spring fittings may release from | Horizontal Track |
| spring if not wound in the proper | |
|
| |
| direction and could result in severe or |
|
| fatal injury. |
|
22 |
|
|
Please Do Not Return This Product To The Store. Contact your local
local yellow pages/business listings or go to the Find a Dealer section online at