![](/images/new-backgrounds/1058660/5866015x1.webp)
1 | Cutting Vertical Track | |
| ||
Tools Needed: | NOTE: If you have riveted track, skip this | |
step. | ||
None | Vertical track must be cut to the proper | |
length prior to installation. | ||
| ||
| IMPORTANT: Doors that are | |
| or | |
| cutting the vertical track. | |
| Determine the radius of your horizontal |
Horizontal track
12”
12” Stamped radius
track. |
NOTE: All Portland tracks have the radius |
stamped on the side of the track. |
Using this measurement, refer to the vertical |
track cutting chart to determine the length |
of the vertical track. Cut the track off at the |
top. |
Now, two holes must be drilled into the |
top of the cut vertical track. Refer to the |
illustration shown for hole locations. Use a |
5/16” drill bit. |
Repeat for other vertical track. |
Vertical Track Cutting Chart |
| ||
Horizontal | Vertical Track Cut Length | Vertical Track | |
Cut Length | |||
Track Radius |
| ||
|
| ||
10”, 12” | Door Height Minus 10” |
| |
14” | Door Height Minus 8” | Cut vertical | |
Door Height Minus 15” | track here | ||
| |||
Door Height Minus 12” |
|
1/2” 5/8”
5/16”
5/8”
2
Tools Needed:
None
Attaching Fully Adjustable Flagangle to Vertical Track
NOTE: If you do not have fully adjustable flag angles, skip this step and continue with step 3.
Hand tighten the flagangle to the vertical track using (2) 1/4” - 20 x 5/8” carriage bolts and
(2)1/4” flange hex nuts. Secure the flange nuts after flagangle spacing is complete (Step 11).
fully
adjustable flagangle
(2)1/4”- 20
Flange hex Nuts
(2) 1/4”- 20 x 5/8” carriage bolts
vertical
track
8
Please Do Not Return This Product To The Store. Contact your local
local yellow pages/business listings or go to the Find a Dealer section online at