Operating Instructions and Parts Manual | JSU50 |
|
|
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for future reference.
Jet Pump
Description
These pumps are single stage domestic water pumps designed for pumping potable water. Shallow well pumps are designed for applications where the water level is less than 25 feet below the pump. Flammable liquids such as gasoline, chemicals, or corrosive liquids should never be used with these pumps.
Unpacking
Inspect this unit before it is used. Occasionally, products are damaged during shipment. If the pump or components are damaged, call Customer Service at
Safety Guidelines
This manual contains information that is very important to know and understand. This information is provided for SAFETY and to PREVENT EQUIPMENT PROBLEMS. To help recognize this information, observe the following symbols.
Danger indicates an imminently
hazardous situation which, if not avoided, WILL result in death or serious injury.
Warning indicates a potentially
hazardous situation which, if not avoided, COULD result in death or serious injury.
Caution indicates a potentially
hazardous situation which, if not avoided, MAY result in minor or moderate injury.
Notice indicates important
information, that if not followed, may cause damage to equipment.
NOTE: Information that requires special attention.
General Safety
Information
California Proposition 65
This product contains chemicals,
including lead, known to the State of California to cause birth defects and other reproductive harm. Wash hands after handling.
1.Read these rules and instructions carefully. Failure to follow these instructions could cause serious bodily injury and/or property damage.
This pump is non- submersible.
Install indoors only or in a pump house.
Risk of electrical shock.
Pump only clear water. Do not pump flammable or explosive fluids such as
gasoline, fuel oil, kerosene, etc. Do not use in a flammable and/or explosive atmosphere. Personal injury and/or property damage WILL result.
This pump is not designed
to handle salt water, brine, laundry discharge, or any other application which may contain caustic chemicals and/or foreign materials. Pump damage could occur if used in these applications and will void warranty.
All wiring must be performed by a qualified electrician. The pump must be installed in compliance with the National Electrical Code and all local codes.
2.Connect this pump to a grounded circuit equipped with a ground fault interrupter device (GFCI).
3.Before installing this product, have the electrical circuit checked by an electrician to ensure proper grounding.
Risk of electric shock! Pump must be disconnected from power source before installing or servicing.
4.Be sure the water source and piping is clear of sand, dirt, and scale. Debris will clog pump and void warranty.
5.Protect pump and piping from freezing. Failure to protect from freezing could cause severe damage and will void the warranty.
6.Follow priming instructions. Do not run pump dry.
Installation
Protect pump from the elements by installing in a basement, garage, tool shed, or pump house. Install the pump so the centerline of the pump is as close as possible to the water level. Keep installation area clear to provide access for service and maintenance. Protect the pump against flooding and excess moisture.
REMINDER: Keep your dated proof of purchase for warranty purposes!
Attach it to this manual or file it for safekeeping.
© 2011, Wayne/Scott Fetzer Company. | For parts, product & service information | |
| visit www.waynepumps.com |
|
