P250AFP265 P250AF-EPP265F, For Your Safety

WAYNE COMBUSTION SYSTEMS

801 GLASGOW AVE.

FORT WAYNE, IN 46803

MODELS

P250AFP265

P250AF-EP P265F

P250AF-DI P265-EP P265-EP

GAS BURNER

Publication Date 5/01 - Revision B - Manual 101220

NOTE: Dimensions in ( ) are informational only. English values take priority.

FOR YOUR SAFETY

IF YOU SMELL GAS:

1.OPEN WINDOWS

2.DON’T TOUCH ELECTRICAL SWITCHES

3.EXTINGUISH ANY OPEN FLAME

4.IMMEDIATELY CALL YOUR GAS SUPPLIER.

CARBON MONOXIDE

POISONING HAZARD

CARBON MONOXIDE IS A COLORLESS, ODORLESS GAS THAT CAN KILL. FOLLOW THESE RULES TO CONTROL CARBON MONOXIDE.

▲Do not use this burner if in an unvented, enclosed area. Carbon monoxide may accumulate.

▲Do not adjust the pressure regulator. High pressures produce carbon monoxide.

▲Check flue gases for carbon monoxide. This check requires specialized equipment.

▲Allow only qualified burner service persons to adjust the burner. Special instruments and training are required.

▲Read the owner’s manual before using.

OVERHEATING HAZARD

SHOULD OVERHEATING OCCUR:

▲Shut off the manual gas valve to the appliance.

▲Do not shut off the control switch to the pump or blower.

WARNING: If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.

-Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

-WHAT TO DO IF YOU SMELL GAS

•Do not try to light the appliance.

•Do not touch any electrical switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas supplier, call the fire department.

-Installation and service must be performed by a qualified installer, service agency or the gas supplier. Warranty is voided if not installed by qualified service person.

ELECTRIC SHOCK HAZARD

HIGH VOLTAGES ARE PRESENT IN THIS EQUIPMENT. FOLLOW THESE RULES TO AVOID ELECTRIC SHOCK.

▲Use only a properly grounded circuit. A ground fault interrupter is recommended.

▲Do not spray water directly on burner.

▲Turn off power before servicing.