Step 29
Install tool holders, control panel and burner control knobs
You will need: three tool holders, control panel, two Phillips screws/washers, a Phillips screwdriver, and three burner control knobs.
Hook the tool holders over the frame rail. Figure 42.
Set the control panel in place over both frame braces. (Hold the Crossover Ignition button up while setting the control panel in place.) Line up the holes in the control panel with the holes in the inserts in the frame brace. Insert screws and tighten with a Phillips screwdriver until snug. Do not overtighten. Figure 42 (a).
Push on the burner control knobs. Figure 42 (b).
Insert in
frame brace
(a)
Crossover
Ignition Button
Phillips screws/
washers
(b)
Tool holders
Figure 42
Step 30
Secure the side burner
Pull the right hand swing table up. Stand to the right side of the barbecue. Slightly pull back both side burner locks. Slide the side burner toward the control panel. The locks will snap into the slots in the front and back of the side burner. Figure 43.
mCAUTION: Make sure both locks have snapped into place.
View from top
Side view
Figure 43
26
