Weber 3400 Series owner manual Install tank panel assembly, Install right end panel

Hose and regulator

Step 14

Install tank panel assembly

You will need: tank panel assembly.

Slide the side burner back. Insert the tabs into the slots in the frame brace at the wheel legs. (Make sure the side burner hose is to the front of the barbecue.) Figure 16 (a). Slide up until the notch at the bottom of the tank panel fits over the cross brace. Figure 16 (b).

Slot in frame brace

(a)

Frame brace

	Tabs on tank panel
Side burner	(b)
hose

Figure 16

Cross brace

Step 15

Install right end panel

You will need: right end panel (Number 3), 1/4-20 x

1 1/2 inch bolt, 1/4-20 hex nut, two nylon washers and a 7/16 inch wrench.

Set the right end panel in place with the flange at the top facing away from the barbecue, and the bottom flange under the frame brace. Figure 17.

Make sure the gas supply hose is on the outside of the panel. Put washer on bolt and insert bolt through both panels and frame brace. Add washer and hex nut and tighten. Figure 17.

Side burner hose

Figure 17

17