AT&T 3 manual Installing the Mail System, Mounting the System Unit

Installing the Mail System

Installing the Mail System

Installation involves the following activities:

■Mounting the system unit.

■Connecting the system unit to the communications system.

■Connecting the Remote Maintenance Device to the system unit.

NOTE:

The illustrations show a six-port system; if you are installing a two-port or four-port system, it will look slightly different.

Mounting the System Unit

1.Position the bracket against the wall so that the hanger slot is located near the top, as shown in Figure 2-1.

Wall

Hanger

Slot

Bracket Cable Manager

Wood Mounting

Surface

Figure 2-1. Mounting the Bracket

2.Using the bracket as a template, mark the four points on the wall where the screws will be inserted.

WARNING:

Be sure the bracket will be screwed into wall studs or a piece of plywood to ensure permanent mounting and to prevent wall damage.

Installation 2-5