AT&T 3 manual Logging In to System Administration

Logging In to System Administration

2.At the Extension: prompt, enter the extension number where the Remote Maintenance Device (VMS-RMD) is installed as specified on communications system Planning Form B1.

3.Press [ Remove ] to remove all existing line assignments.

4.Continue with “Automatic Extension Privacy.”

Automatic Extension Privacy for the

Remote Maintenance Device

Use this procedure to assign Automatic Extension Privacy to the extension to which the Remove Maintenance Device is connected so that users cannot interrupt transmission.

1.Press [ # ] [ 3 ] [ 0 ] [ 4 ].

2.At the Extension: prompt, enter the extension number where the Remote Maintenance Device (VMS-RMD) is installed as specified on communications system Planning Form B1.

3.Press [ Next Data ] until the display reads 1 Assigned.

4.Press [ Feature ] [ 0 ] [ 0 ] to exit programming.

Logging In to System Administration

To program the mail system, you will log in to the System Administrator’s mailbox and access the System Administration Menu.

For initial programming, you will use the factory setting for the System Administrator’s mailbox. The System Administrator’s mailbox password and the Administration password are not factory-set, so you will be prompted to set them. Be sure the System Administrator knows the passwords that you choose, because the System Administrator will need them in the future to log in.

Security Alert:

It is strongly recommended that the System Administrator change the System Administrator’s mailbox password and the System Administration Password after initial programming is complete. Instructions are provided at the end of this chapter.

1.Press [ Intercom ] [ 7 ] [ 7 ] [ 7 ].

The Voice Mail Greeting plays, followed by the extension prompt.

Mail System Initial Programming 3-5