AT&T 3 manual After Initial Programming, Assigning the System Administrator’s Mailbox Password

After Initial Programming

After Initial Programming

When initial programming is completed, notify the System Administrator of the passwords you have assigned. Then work with the System Administrator to change the passwords, using the following procedures.

Security Alert:

It is strongly recommended that the System Administrator change the System Administrator’s mailbox password and the System Administration Password after initial programming is complete.

Assigning the System Administrator’s Mailbox

Password

The System Administrator should perform the following procedure:

1.Log in to the System Administrator’s mailbox.

a.Press [ Intercom ] [ 7 ] [ 7 ] [ 7 ].

b.Enter the System Administrator’s mailbox number + [ # ].

c.Enter the System Administrator’s mailbox password + [ # ].

2.Press [ 5 ] to change the password.

3.Enter a new password + [ # ]. For system security, make the password a difficult-to-guess value.

4.Re-enter the new password + [ # ].

This new password must be used in the future to log in to the System Administrator’s mailbox.

Assigning a System Administration Password

The System Administrator should perform the following procedure:

1.Log in to System Administration.

a.Press [ Intercom ] [ 7 ] [ 7 ] [ 7 ].

b.Enter the System Administrator’s mailbox number + [ # ].

c.Enter the System Administrator’s mailbox password, as assigned in the procedure above, + [ # ].

d.Press [ 9 ] for System Administration.

e.Enter the System Administration password + [ # ].

3-34Mail System Initial Programming