AT&T 3 manual Introduction

Communications System

Initial Programming

Introduction

This chapter contains procedures for communications system features that must be programmed for proper operation of the mail system. This information assumes that communications system forms have been completed and that you are familiar with communications system programming.

For information about communications system forms, refer to Appendix B. For information about communications system programming and features, refer to the Programming and Use guide for the communications system.

References to forms throughout this chapter are based on communications system Release 4.1 forms. The terminology and page numbers may vary slightly on forms for other releases of the communications system.

The procedures in this chapter assume that this is the first time a mail system is being installed on an existing communications system. If this is not the case, some of the communications system’s settings may already be changed to the values specified here. It is recommended that you perform each procedure and verify all of the settings.

Before You Begin

Before you begin, locate communications system Planning Forms A, B1, B2, C and D.

Communications System Initial Programming 4-1