Insert one end of the hinge rod into the hole in the frame. Figure 27 (a).
Insert the other end into the hole in the swing table end bracket. Figure 27 (b). Hold the end bracket at an angle so the lower tab is inside the frame tube. Push the bracket into the frame. Check to see that the lower tab of the bracket is hooked in the slot in the frame. Figure 27 (c).
To fully seat the bracket, you may have to tap it lightly with a hammer.
mWARNING: If swing table end bracket is in any way cracked or damaged, do not use swing table. Contact your dealer to order a new part.
mWARNING: The load limit for the swing table is 30 pounds.
(a)
(b)
Hinge rod
View from rear of barbecue
(c)
Position slide bar assembly on the outside of the wheel frame. Put a nylon washer on each 1 3/4 inch screw, insert screws through frame and slide bar assembly and add nylon washers and hex nuts. Tighten nuts using a screwdriver and pliers. Figure 28.
Notch
F | Slide bar |
|
F
View from front of barbecue
Wheel frame
Figure 28
To lower table: Pull support rod up to disengage slide lock and lower table. To raise table, lift table up and engage slide in locked position. Figure 29.
Support rod
Figure 27
Slot in frame (view from below)
Slide
Unlocked position | Locked position |
Figure 29
21
