7) Check for leaks by wetting the fitting with the soap

and water solution and watching for bubbles. If

bubbles form, or if a bubble grows, there is a leak.

2) Loosen the cylinder lock wing nut. Swing the

 

cylinder lock down. Tighten the wing nut.

 

To Connect the hose to the cylinder:

 

3) Remove the plastic dust cover from the valve.

 

4) Screw the regulator coupling onto the tank valve,

 

clockwise, or to the right. Hand-tighten only.

 

Note: This is a new type of connection. It tightens

If there is a leak, turn off the gas and tighten the fitting.

clockwise and will not allow gas to flow unless the

Turn the gas back on and recheck with the soap and

connection is tight. The connection requires tightening

water solution.

by hand only.

If leak does not stop, Contact the Customer Service

m WARNING: Do not use a wrench to tighten the

Representative in your region using the contact

connection. Using a wrench could damage the

information sheet provided with your manual. Do not

regulator coupling and could cause a leak.

use the barbecue.

5) Mix soap and water.

8) When leak checking is complete, turn gas supply

6) Turn on the cylinder valve.

OFF at the source and rinse connections with

 

 

water.

Liquid Propane Cylinder

The liquid propane cylinder manufacturer is respon- sible for the materials, workmanship and performance of the tank. If the tank has a defect malfunctions, or you have a question regarding the tank, call the tank manufacturer’s customer service center. The phone number is on the warning decal, which is permanently attached to the tank. If the tank manufacturer has not resolved the issue to your satisfaction, then contact the Customer Service Representative in your region using the contact information sheet provided with your manual.

D-5

Page 22
Image 22
Weber Gold B manual To Connect the hose to the cylinder, Connection. Using a wrench could damage, Liquid Propane Cylinder