2.Attach the Crossbar (2) to an Upright (1) with two M10 x 70mm Bolts (27), two Joint Plates (11), and two M10 Nylon Locknuts (31). Do not tight- en the Locknuts yet.
Repeat this step with the other Upright (1).
3.Attach the Front Leg (4) to the Stabilizer (5) with two M10 x 65mm Carriage Bolts (26) and two M10 Nylon Locknuts (31). Do not tighten the
Locknuts yet. Make sure that the indents around the holes in the Stabilizer are on the bottom.
4.Attach the Front Leg (4) to the Bench Frame (3) with two M10 x 50mm Bolts (28), two M10 Washers (30), and two M10 Nylon Locknuts (31).
Do not tighten the Locknuts yet. Make sure the bolt heads fit inside the hexagon holes in the Bench Frame.
2 |
|
| 1 |
| 1 |
| 31 |
11 | 11 |
| |
27 | 2 |
| |
3 |
|
| 4 |
| 31 |
| 31 |
| 5 |
Indents |
|
| 26 |
4 |
|
31 | 30 |
| |
30 | 3 |
| |
4 | 28 |
Hexagon | |
| Holes |
7
