7.Press a 50mm x 75mm Inner Cap (58) into the top of the Squat Upright (4). Press two 25mm Round Outer Caps (120) onto the Upright.
Slide the Squat Upright onto the two indicated M10 x 65mm Carriage Bolts (110) in the Long Base (106). Finger tighten an M10 Nylon Locknut (87) onto each Carriage Bolt. Do not tighten the
Locknuts yet.
Press a 50mm x 75mm Inner Cap (58) into the top of the Swivel Upright (5). Slide the Swivel Upright onto the two indicated M10 x 65mm Carriage Bolts
(110)in the Long Base (106). Finger tighten an M10 Nylon Locknut (87) onto each Carriage Bolt. Do not tighten the Locknuts yet.
8.Press two Swivel Bushings (66) into the Swivel Carriage (46).
Tighten an Adjustment Handle (65) into the Swivel Carriage (46). Orient the Swivel Carriage as shown. Slide the Carriage onto the Swivel Upright (5) and engage the Adjustment Handle into an adjustment hole in the Swivel Upright.
7 |
|
58 |
|
58 |
|
5 |
|
4 |
|
87 |
|
| 120 |
120 |
|
110 | 87 |
106 | |
110 |
|
8 |
|
66 |
|
46 |
|
65 |
|
66 |
|
5 |
|
Adjustment |
|
Hole |
|
8
