2.Attach a Wheel (31) to the outside of the Base (1) with a 3/8” x 4 1/4” Bolt (81), three 3/8” Washers (75), and a 3/8” Nylon Jamnut (103). Do not overtighten the Jamnut; the Wheel must be able to turn easily.
Attach the other Wheel (not shown) in the same manner.
3.Press a 1 1/2” x 2 1/2” Inner Cap (41) into each end of the Cross Tube (11).
Orient the Cross Tube (11) as shown, with the welded tubes at the bottom. Attach the Cross Tube to the Upright (3) with two 3/8” x 5 1/2” Carriage Bolts (73), two 3/8” Washers (75), and two 3/8” Jamnuts (57).
4.Press a 1 1/2” x 3” Inner Cap (99) into the top of the Front Leg (6). Press the Front Leg Foot (27) onto the bottom of the Front Leg. Note that the front of the Front Leg Foot is taller than the back.
Press a 1 1/2” x 3” Inner Cap (99) into the end of the Bench Rail (5).
Attach the Bench Rail (5), with the hook on the bottom, to the Front Leg (6) with two 3/8” x 2” Carriage Bolts (61) and two 3/8” Nylon Jamnuts (103).
5.Lubricate a 3/8” x 4” Bolt (66) with grease. Attach the Bench Rail (5) to the Upright (3) with the Bolt and a 3/8” Nylon Jamnut (103). Do not over- tighten the Jamnut; the Bench Rail must be able to pivot easily.
Tighten the Storage Knob (30) into the Upright (3) and the Bench Rail (5).
2 |
|
|
|
|
|
| 103 | 75 |
|
|
|
|
| 75 |
|
|
|
| 81 |
|
|
| 31 | |
|
| 1 |
|
|
3 |
|
|
|
|
| 3 |
| 75 | 57 |
|
|
|
| |
| 41 |
|
| Welded |
|
|
|
| |
73 |
|
|
| Tube |
|
|
|
| |
|
|
| 11 |
|
|
|
|
| 41 |
| 73 |
|
|
|
4 |
|
|
|
|
| 99 |
| 5 | 99 |
|
|
| ||
|
|
|
| |
| 103 |
|
| Hook |
|
|
|
| |
61 | 103 |
|
| |
|
|
|
| |
Front | 6 |
|
|
|
|
|
|
| |
| 27 |
|
|
|
5 |
|
|
| 30 |
|
|
|
| |
|
|
|
| 3 |
| Insert the bolt | 103 |
| |
| through this hole |
|
|
|
| 5 |
|
| 66 |
|
|
|
| |
|
|
|
| Lubricate |
6
