26.Slide the Pad Tube (50) into the Leg Lever (56). Slide two Large Foam Pads (52) onto the Pad Tube.
Attach the other Pad Tube (50) to the Leg Lever (56) and the Leg (5) in the same manner.
27.Attach a 90mm Pulley (40) inside of the Leg (5) with an M10 x 85mm Button Bolt (92), two M10 Washers (106), two 22mm Spacers (61), and an M10 Nylon Locknut (103).
28.Wrap a High Cable (101) over a 90mm Pulley
(40).Attach the Pulley to a Pulley Housing (39) with an M10 x 44mm Button Bolt (93) and an M10 Nylon Locknut (103).
Repeat this step with the other High Cable
(101)and Pulley Housing (39).
29.Make sure that all parts have been properly tight- ened. The use of the remaining parts will be explained in ADJUSTMENTS, beginning on the following page.
26 |
|
52 |
|
56 |
|
5 | 50 |
50 |
|
| 52 |
27 |
|
103 | 5 |
106 | 61 |
| |
61 | 106 |
40 | 127 |
| |
28 |
|
| 39 |
103 | 93 |
40 | 101 |
Before using the resistance system, turn on the console and change the resistance setting as described in CONSOLE OPERATION on page 18. Refer to TROUBLESHOOTING on page 21 and adjust the Crossbar Cable ten- sion as described.
13
