19.Insert the Resistance Bar (9) between the Bar Guides (15), and center it on the Block Spacer (not shown).
Remove the paper backing from a Bracket Plate (11) and stick it to the end of Resistance Bar (9). Press a Pulley Bracket (10) onto the Resistance Bar. Screw a 3/8” x 38mm Tension Screw (13) into the Pulley Bracket a couple of turns. Make sure the hexagonal hole in the Screw is on the outside of the Bracket.
Attach a Tether (70) to the Pulley Bracket (10) at the upper hole, with an M10 x 64mm Button Bolt (80), an M10 Thick Washer (54), and an M10 Nylon
Locknut (103).
Repeat on the other side of the Resistance Bar (9). Then, tighten the lower M10 x 152mm Bolt (86) used in step 18.
20.Hold a Large Pulley (14) inside the upper cable
(A). Attach the Pulley to a Pulley Bracket (10) with an M12 x 58mm Button Bolt (87) and an M12 Nylon Locknut (43). Make sure that the cable is routed as shown in the CABLE DIAGRAM on page 20.
21.Hold a Large Pulley (14) inside the upper cable
(A). Attach the Pulley to the other Pulley Bracket (10) with an M12 x 58mm Button Bolt (87) and an M12 Nylon Locknut (43). Make sure that the cable is routed as shown in the CABLE DIA- GRAM on page 20.
Tighten the two 3/8” x 38mm Tension Screws
(13)an equal number of turns until the upper cable (A) is tight.
22.Attach a Plastic Foot (36) to the Backrest Frame
(32)with an M4 x 16mm Screw (53).
19 |
|
|
|
15 |
|
|
|
|
| 70 |
|
|
| 54 | 103 |
| 9 |
| |
|
|
| |
|
| 11 |
|
|
| 10 |
|
|
| 80 | 13 |
|
|
| |
20 |
|
|
|
43 |
|
|
|
10 |
|
|
|
87 |
|
|
|
14 |
|
|
|
A |
|
|
|
21 |
|
|
|
|
| 43 |
|
|
| 13 |
|
A |
| 10 |
|
87 |
| 14 |
|
22 |
|
|
|
32 |
| 36 |
|
| 53 |
| |
|
|
|
11
